Replacement Fuel Pump Part Numbers (Post #447) 2/10/2014

I was reading a post on the Facebook Land Rover Owners page about the replacement of a fuel pump on a Land Rover Defender. The North American model Defender uses many of the same parts as a Range Rover Classic and Discovery I. If you are a regular reader of the blog you know I’ve just recently replaced my fuel pump and now have a spare unit waiting for the electric pump on the shelf.

https://okierover.com/fuel-pump-replacement/

I’ve posted many times about the prices dealers charge for parts. The major parts houses have good prices but often charge more for a part when an equivalent part can be fond for cheaper if you only knew what the part numbers were.

Auto zone in Boise tried quoting me over $1,000 and I called BS. Is there a certain part number so they don’t try misquoting the price? – Cameron Eugene

 

We all try to find a cheaper price. It is common for a parts supplier to hear Range Rover or Land Rover and they immediately think the owner is made of money.

MONEY-BOAT-web-image-blog
Nearly every one with a television has seen the Geico “Made of Money” commercials.

The gentleman doing the swap is John Monaghan. John works for GB 4×4 Radios. These are the fine folks that upgrade and repair the radio units for Land Rovers.

He had a friend that worked at an Autozone and he let him “browse” the stock to find the right parts. The following quotes are John’s from the thread:

Thank God I have a buddy at Autozone that let me go to the back and look in every box. Ask for this EP375 from a Chevy, now they have it and for just $87. This is priceless info for my fellow American Land Rover brethren, enjoy and save a mint.

acdelco

Even the top electrical connection is the same.
Or you can use US auto store O’Reilly’s. Part numbers there is Delphi: FE0110. And sock filter is Delphi : FS0001.

delco

There are two small plastic lugs on the bottom of the new pump that have to snipped off, dead easy, this way it sits fully in your old base, then you will have to use a new fuel line with two metal hose clamps or in UK Jubilee clips. Job done and a mint saved!

clampWhile I’m here I might as well add this pics, shows both lugs snapped off as needed with needle nose pliers, clamp and the hose size you need

Jeffrey Baker added this for the thread:

Pump fits many V8 GM fuel injected motors. $72 for the Delphi or Bosch part#69218 at NAPA. Carter equivalent is $52 part #p74006. Airtex also makes this pump not sure of number though.

Denis Guyvner added this helpful tip:

I have also heard that what causes these to fail is continually running your fuel level at a low amount. The fuel pump needs the fuel to keep it cool. Heat is what kills the pump.

And finally John Monaghan added this final note:

FYI: I’ve done this A/C Delco fuel pump swap many times on different Rovers in my collection and have saved a fortune over Dealer and OEM Land Rover parts vendor $$$$ pump prices. Looks like I’m going to be doing another this week (will add DIY pics here and A/C Delco pump part numbers), seems my 1988 Classic’s pump is toast too, sat too long low on gas without starting it, so the fuel dries to a varnish up inside the pump’s rotor… locking it solid, then you try several times to start it, the armature in the pump’s electric motor does not move so it burns the carbon brush mounts, rendering the pump dead and beyond repair! So never leave your fuel injected Rover parked up with out starting it monthly and with less than 1/2 a tank of petrol. Lesson learned 🙁

So much great stuff in one post. This might seem like a complicated project. It is not. I walk through it almost step by step in my link above. With a little deductive reasoning most anyone should be able to swap the pump out of the unit especially if it is a near direct swap.

Thanks to all the guys on the thread and thanks to John for great details. It will save us all several hundreds of dollars.

Thanks for reading, check out the Facebook group Land Rover Owners, and Happy Rovering.