After I took the Christmas lights off the house I moved the Range Rover into the shelter of the garage. It’s a little bit chilly out there and being out of the wind seemed like a good idea.
The first annoying problem I looked at was the problem opening the driver’s side door. As most of you Land Rover owners have experienced, the flappy-paddle-trapeze of opening a Range Rover Classic door is silly. Once it gets out of adjustment it’s pretty frustrating trying to get your doors open. To top it off my door especially doesn’t like to open when it is cold out.
I pulled the door card and looked for the outside handle’s adjustment rod. To adjust it you remove the keeper clip at the top and then turn the rod clockwise. I chose to turn it four revolutions. I hooked it back up and then tested it.
Worked just as I expected it to, perfectly. The inside handle needed adjustment too. For this rod you trace it from the handle to the end that attaches to the trapeze bits. It has a “Z” in the rod and a spring to keep it in place. On the end it has a 7mm nut. It’s not fun to find the end and get the wrench on it.
I gave it at least a full revolution. The inside handle now engages the release a little sooner. This is better than the last time when I got a bit carried away and couldn’t get the door open after adjusting it.
The second was getting the unlock lever back into it’s guide. I had removed this when I had trouble getting the door panel reattached to the door. The guide broke and I didn’t bother to reinstall it until today.
The broken guide I had glued broke again. I installed it anyway. I think it looks better than just the lever floating around in a hole in the door card.
When the door card was off I investigated the electric door actuators. Mine have become weak and cause the famous “bouncing lock problem“. Since those initial investigative blog posts I’ve learned the actuators weaken and don’t set the lock correctly and cause the lock and unlock issue. Replacing the actuators fixes the issue in some instances.
I then turned my attention to the center brake light. It has not worked for a while. I thought it was a burned out bulb. A few months ago I check it and the bulb was just bouncing around loose in the lamp fixture. So I swapped the bulb, still no light. I made the sure the bulb was making a good connection. I then traced the wires to the plug under the headliner. I found two plugs that did not match. I guess when I replaced the upper rear door frame they sent me a frame with the wrong plug on it.
I went out to my old frame, which I kept because it has good glass still in it. I had cut the old plug off. I guess in my haste to reinstall I didn’t swap the plug. Well long story short the plug is in a box somewhere and instead of digging through boxes for hours, I decided that I’d just splice the wires. Once completed, my center brake light now works again.
The last thing was the Range Rover letters on the tailgate are coming unglued. After I worked on the brake light they were all but coming off. In fact the A did come off.
I got some rubbing alcohol out and cleaned up the glue locations. I got some glue and decided to attempt to glue them back into place. If it fails again, I have another sticker I can replace them with.
So today I knocked out these little annoying things. Not a bad day if I say so myself. I wish I had time to work on the radio too but it will have to be another day.
It’s January. S.C.A.R.R. is in April. If you can make it to S.C.A.R.R. now is the time to plan for it. If you are from Oklahoma contact me, I’d like to get us in matching shirts and make a good club showing. I promise you will have a good time.
Thanks for reading, Happy New Year, and Happy Rovering.