Part 1 of the Bumper Project. I mocked up a new bumper using cardboard. It will likely be 5×3 inch tube with rear fender protection. I got the idea from the PFab Youtube channel. You can check out his video in a link on mine.
If you remember the old bumper was damaged by an inattentive driver of a Hyundai reaching over to pick up a jar of spaghetti that had rolled off her seat [Okierover.com].
I’ll post another video when I get closer to pulling the trigger on this project. List of needs:
- Welder
- Plasma Cutter
- Steel
I don’t have any of those things at the moment. I’ll have at least as much invested in those items as a new bumper from RTE would cost WITHOUT the tire carrier and jerry can holder. But I’ll have a welder at the minimum and maybe even a plasma cutter when I’m done.
If I hit the lottery, I’ll still buy the welder and plasma cutter, but I’d probably consider buy a RTE bumper built to spec.
Thanks for reading/watching and Happy Rovering.