I have some good news and I have some bad news….
The good news…I have the swimming pool setup and I’ve been in it twice this weekend.
The bad news…I still suck at welding. In my defense this part of the Range Rover Classic is a mish-mash of panels converging into a very small space. There are no less that three different pieces in this area that are plug welded and the gaps filled with seam sealer. In a future video when I build the rest of of the upper wheel well, I will point out the three layers of panels that go into building the wheel well. It’s so convoluted that screws were even used to hold the parts together. SCREWS!
Anyway. I build my replacement parts and attempted to get them married together. Ironically I have three pieces of metal to get this done. Well four if you count the patch of the side bulkhead.
Did I say it was hard to weld under there? NO? Well it’s damn hard to weld under there. You have basically two positions. Mashed up against the wheel hub and laying on the ground with welding slag (molten metal) falling on you. Both, super awesome as you can well imagine.
I said I was swimming earlier in this post. While sitting on the patio drying off Mrs. Okierover noted the weird red scratches on my right arm. I told her they were from being mashed up against the hub.
Manufacturing the repair pieces was a bit of folly too. I had to make the “L” three times. First time was an experiment to see if I could make a bended L. The second was because I measured the piece without the floor panel in the right place. The third time was a charm or I decided that was going to be the last time I made it and I made it work.
Don’t get me wrong, careful thought was expended. A LOT of thought. And in the end I was still wrong but not by much.
With a lot of clamping and grinding and grunting I have the pieces welded together. The welds are ugly. A lot of seam sealer will be used to discourage water from coming in these seams. Probably about as much as was used by the factor but the difference is my metal is covered with primer. Theirs was not. To protect this section I will rely on primer, at least three coats. Rust encapsulator will also be liberally applied. And over that, rhino/bed liner. Inside the cab will also be a layer of Fat Mat.
Will all this work and product prevent rust? Probably not. Who are we kidding? The Range Rover Classic was built to rust. The goal was that it rusted out on the second or third owner. I had the added bad luck that my Range Rover was a victim of a front end wreck before I owned it. Sports and Classics did the best they could to weld a donor front end on to the rear half. And I’m doing my best to keep rust at bay the best I can.
There were 19 segments filmed over two days. I left a lot of the welding out of the video. Mostly because it was difficult enough for me to get into place to weld, there really wasn’t any room for a camera.
It was hot in the shoppe too. Temps at or above 100F (37.8 C for those of you living in countries that have never had a man on the moon). The camera overheats when I’m filming in these temps. So the camera sat on the air conditioner when I wasn’t filming. I wonder if anyone makes a camera that can do warmer temps? My next camera will be evaluated for temps.
This weekend was Memorial Day.
Freedom is not free. So many have given everything they had to keep you free.
Remember those and their great sacrifice.
Thanks for reading and Happy Rovering.
Like and subscribe.