Upper Tailgate Repair on a Range Rover Classic, Part 3 (Post #673) 9/29/2024

In this post I finish up the upper tailgate repair. I finished up all the rust removal and put the frame back on.

This went “good”, I guess. I broke one bolt on the passenger side latch mechanism. I didn’t finish the seal. There were two holes that the rivets would not work in. I tried to tap them for a 10/32 bolt. I need to but the bolts and see if my tapping worked.

I tested the latch but it didn’t work super great. So I have some more work to do to get that adjusted again. It was working perfectly before I took it apart. So it may need more adjusting.

I took a few minutes to investigate where my backup camera will need to be mounted. I’ll have to experiment more once the head unit is installed. I only get one shot at drilling and installing. I gotta make it count.

I didn’t get to finish the job this weekend. One, the tapped screws did not get bought. Two, we had torrential rains happen today. At one point the rain was falling at 2 inches an hour. It slowed down some and in the end we got 5 inches of rain in 6 hours. It’s still sprinkling. This will break the drought we were under.

Next week I’ll wrap up the tailgate probably off camera. Next project is the rear floor. I still haven’t sorted out how I’ll get the rust off. So that’s the research I need to do this week.

Like and subscribe.

Thanks for reading, and watching, and Happy Rovering.

One Reply to “Upper Tailgate Repair on a Range Rover Classic, Part 3 (Post #673) 9/29/2024”

Comments are closed.