Part 2 of a 2 part video series for repair of the B Pillar. In this video I cut (poorly) and weld (even more poorly) the premanufactured B pillar end cap on to the Big White Bus.
All the measuring in the world could not have prevented me from screwing up the B pillar end cap. Not having the right tool, I should have used a bandsaw for the cut, led to me making a bad cut. Probably didn’t help that my measurement was off by 1/8 of an inch. Leading me to attempt to bridge that gap with welds. I had…mixed results.
I was careful, real careful, measured more than once. None of that kept me from cutting this wrong. What’s worse cutting too long and then cutting too much off trying to fix it OR cutting it too short on the first try???!!!?
Thankfully this entire section will be reinforced and protected with a rock slider at some point in the future. My worst fear is this rusting out again. Or maybe its not… at some point this entire vehicle may become scrap. Only the Fates know.
Thanks for watching. Like and subscribe.
Thanks for reading and as always Happy Rovering.
Hyperlink to the video https://youtu.be/rQdrRkAOw_k