Surface Rust Under the Passenger Side Fender (Post #635) 12/18/2023

In this short video I take care of the surface rust I found under the passenger side fender. There were some unpainted surfaces notably under the rubber washers at the top of the quarter panel. There were also some pin hole spots of rust.

They look like dirty spots until you put the wire wheel on them. Is that primer? this stuff Land Rover used under the panel just flaked off in spots. In the video there is a segment that has some leopard spots…that’s where the paint just came off.

The two rust spots in the arch will be ground down again. I don’t think I need to fix them, just stop the rust. The holes are on the outside of the vehicle so water getting in won’t be from these two spots.

I wire wheel all the rust I could see. Then I washed the panel with acetone. This was to remove any lingering dust, dirt, oil, whatever.

I then coated the panel with primer in a green color I really like. I could see myself driving a vehicle painted like that. I’ll watch the weather and give it all a second coat when it warms up a bit. The temp in the shoppe was 54F when I started the work and 52F when I started painting. That’s just barely above the paint range listed on the side of the can.

A big shout out to my fans in Norway. 31 views from that country on 12/12! Tusen takk!

If you are enjoying the content, like and subscribe. Okierover Patreon.

Thanks for reading and Happy Rovering.

Social Media Auto Publish Powered By : XYZScripts.com